Build your own personal computer (PC) to better control the cost and specifications. The first two PC parts to buy are the computer case and motherboard. After the motherboard installation is complete, the next step is connecting the power button, reset switch and hard drive LED.
Instructions
1. Locate the cables for the power button, reset switch and hard drive LED. The cables are connected to the interior of the front plate of the pc case. Untie and separate the cables if needed.
2. Flip the cables over to read the names labeled on the connectors. For example, the label for the hard drive cable typically reads "HDD LED."
3. Refer to the motherboard manual for the locations of the PN1 and PN2 connector groups. Connect the cables to the designated connectors to ensure proper installation.
4. Find the corresponding set of pins for the power, reset switch and hard drive LED on the motherboard. The pins are typically labeled "PWSW," "RESW" and "LED."
5. Connect the cables to the corresponding set of pins by lining up the black wire of each cable to the pin labeled "GND," meaning ground.
Tags: hard drive, reset switch, reset switch hard, switch hard, switch hard drive, button reset, button reset switch